Well, name a few good tuners to use. Bare in mind i have a Horshams board so may need another system fitted. What about Greg Gush @ protuner?
And when you compare them to other generic chips? What's the better option out there for people wanting to pay not much for a generic 'stage' chip for an S body?
Anyway, sorry to go of topic
whats will you be using the car for drift/race/road?
the spec of the cam you want will depend on the use, for example you wouldn't want a long duration and high lift on a road car. I had 335 on my teg and it idled like a bitch.
what lift is there with the 256 you're after?
the greddy easy cams are ok with standard springs but for any other for piece of mind i would change springs and retainers
i would also highly recommend greg
Another cock waving thread about which tuner has the biggest dong
What about the discussion regarding the 256's v's the BC264s folks?
hks 264's for me. they are marvelous. seemingly far superior than 256's with only a small compromise in idle and low end.
just a quick one to throw in!
does anyone elce suffer with a load tapping from BC cams??
a mate just baught a 180 with them fitted and he wants em out as he was told the cams are making the noise!!!
Just bougth Tomei Poncam 256° IN/EX for my monster, no point getting 265° unless your going to go for a million RPM limit which is pointless on an SR imho.
I should get about 540bhp on 256°
(i have a full 264° HKS stage 2 head kit, just using the rockers and springs now)
I have a proper SR, Straitcam so will not get these problems, all hail the high port motor
tis not a problem. the vct had to be turned off earlier than standard to get the full potential of the cams. it switches off at 5300rpm now so the cams can do the bizo as early as poss
hmmm cams!
Crower 264 with crower springs standard retainers and trust rocker arm stopper kitm no complaints at all, running forged sr with 3071 tubby. Had valve shims set when installed cams
made 400bhp without any issues on stock cams, so another 100hp on 256 is fine, 264 are too much.
If Tomei released them the d1 cams are 256 with 12.5mm lift