Results 1 to 6 of 6

Thread: powerFC "standard settings"

  1. #1
    Guest Hugh Janus's Avatar
    Join Date
    Jun 2004
    Location
    Essex
    Posts
    7,394
    Rides
    0

    powerFC "standard settings"

    I have searched but can't find exactly what I'm looking for.

    I have a PowerFC, I've connected it up to my car and it powers on but not tried anything beyond that, id like to see if it works correctly

    I'm looking for a set of parameters/settings (and where to find and adjust them) that I can apply to a PowerFC to see if it'll work with my car and run/idle properly.

    Its an S15 with 555cc and a Z32 AFM

    I'm sorry if this has been covered like millions of times....

  2. #2
    I <3 BBS LM Actual_Ben_Taylor's Avatar
    Join Date
    May 2001
    Location
    South East
    Posts
    23,662
    Rides
    0
    Should be enough to just set injectors to 0.8 and select Z32 from the AFM list.

  3. #3
    Guest Hugh Janus's Avatar
    Join Date
    Jun 2004
    Location
    Essex
    Posts
    7,394
    Rides
    0
    Superstar thank you

  4. #4
    I <3 BBS LM Actual_Ben_Taylor's Avatar
    Join Date
    May 2001
    Location
    South East
    Posts
    23,662
    Rides
    0
    It's option 4 for the AFM - 80,VG30 and I think you might need to do 80 rather than 0.8 for the injectors

  5. #5
    Guest Hugh Janus's Avatar
    Join Date
    Jun 2004
    Location
    Essex
    Posts
    7,394
    Rides
    0
    Quote Originally Posted by Actual_Ben_Taylor View Post
    It's option 4 for the AFM - 80,VG30 and I think you might need to do 80 rather than 0.8 for the injectors
    duly noted, thank you

  6. #6
    Guest Hugh Janus's Avatar
    Join Date
    Jun 2004
    Location
    Essex
    Posts
    7,394
    Rides
    0
    Sorry for being this post back.

    I had a chance to throw the ecu into my car, I set everything as instructed but it won’t start, it cranks but that it.

    Should there be a map on it? Or have I missed something else?

    I set ink 1-4 to 80.0%, set Maf to 4

    I did see somewhere about turning boost control off then on again?
    I have an apexi Avcr already plumbed in.

    Not sure how the boost control would stop the engine from firing up

    Any other suggestions?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •