-
Guest
Headlight bulbs
Hello guys i need help,
My pass side head bulb had failed it has a hid upgrade (shit job) but i want to put them back to OEM,
Question 1 are headlight low beam h1? The old hid was but jist want to make sure?
Question two where can i get a replacement bulb socket?
Question 3, there are two wire green and black im assuming i can just solder them onto the new socket and it should work is this correct ?
Thanks guys
My car is a s14a 1998 plate
-
living on the edge
Yes both the bulbs are H1
Don’t know about the other answers
-
Guest
The H1 bulbs have only one pin. They ground through the body of the bulb.
Any hid kits I've seen just replace the standard H1 bulbs. If this is the case the standard H1 bulbs should slot in to a metal ring to allow for grounding (bearing in mind the notch on the body of the bulb only allows it to fit one way) and then positive power is applied to the back which you could do with a female spade connector of the right size.
Sent from my LYA-L09 using Tapatalk
-
Guest
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules