-
Guest
Automatic to manual conversion CA18DET
Hi I'm a bit of a rookie when it comes to the technical side of things but me and my dad have been working on a 1991 S13 Automatic 1.8L turbo, I'm looking to convert the car to manual and have been reading threads on here about how to go about it which have been really in depth and helpful. However I'm looking for the parts I need online and am just wondering if anyone knows where the best place would be to get them for cheap as the parts are quite expensive. I have a manual gearbox and pedals but that's it and a lot more is required for the conversion. If anyone has any advice on where to obtain these parts for cheap and exactly what parts I need it would be greatly appreciated. Thanks, Noel.
-
Dorset & Hants Rep
Gearbox with shifter
Manual gearbox cross member and mount
Manual flywheel with bolts
Clutch
Gearbox dust shield
Front section of prop
Clutch pedal, master cylinder, slave cylinder and braided line.
Auto ecu will work fine.
Bridge the inhibitor wire.
Dependent on power goals as to which clutch you buy.
Conceptua performance can supply clutch master, slave and braided line.
I have a dust shield you can buy.
For the other parts id put up a wanted thread on here and driftworks but unfortunately cheap isn't really a thing any more unless you're very patient.
Sent from my SM-G960F using Tapatalk
-
Guest
Cheers for information mate I'll put up a wanted thread on here then.
-
Guest
Don't forget to replace the spigot in the crank end with a bush for the input shaft.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules