Results 1 to 5 of 5

Thread: Rear diff cover plate sensors?

  1. #1
    Guest ps13ben's Avatar
    Join Date
    Dec 2017
    Location
    Kent
    Posts
    194
    Rides
    0

    Rear diff cover plate sensors?

    Hi all,

    I have a rear diff cover plate with what I can only guess was 2 sensors pictured in the lower part of the plate that has now got bolts in that leak somewhat.
    I was just wondering if anyone knows the hole size and thread pitch so I can get something that threads properly into the holes and seals them up a lot better.


  2. #2
    Guest
    Join Date
    Jun 2009
    Location
    walsall/tamworth
    Posts
    6,647
    Rides
    0
    the sensors are fot the oil coler system.
    just pop them out and take them to an industrial hose supplier and ask for some blanks. they are probably a tapered thread

  3. #3
    Guest ps13ben's Avatar
    Join Date
    Dec 2017
    Location
    Kent
    Posts
    194
    Rides
    0
    I would have done that but I physically donít have the sensors, I previously put a M10 nut and bolt through the hole to seal them which did for a period of time. Now Iím after a more permanent solutionÖÖ
    Looks like Iíll have to remove the diff and measure the holes and thread pitch.
    Itís a pain as I only wanted to remove the rear cover once


    Sent from my iPhone using Tapatalk

  4. #4
    I <3 BBS LM Actual_Ben_Taylor's Avatar
    Join Date
    May 2001
    Location
    South East
    Posts
    23,600
    Rides
    0
    If an M10 is slightly loose then they're probably 1/4BSP

  5. #5
    Guest ps13ben's Avatar
    Join Date
    Dec 2017
    Location
    Kent
    Posts
    194
    Rides
    0
    Thatís a good shout thanks Ben, Iíll see if I can get at it this weekend and report the findings


    Sent from my iPhone using Tapatalk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •