Results 1 to 2 of 2

Thread: PTFE Braided Connections

  1. #1
    Guest
    Join Date
    Apr 2015
    Location
    Lincolnshire
    Posts
    161
    Rides
    0

    PTFE Braided Connections

    So without planning this ahead I've got some PTFE braided (-8 and -6) hose for use as fuel lines on my s14.

    If anyone else is using these, how have they connect the hose to the fuel top hat / sender? The top hat uses barb fittings, which obviously is no good for the PTFE hoses.

    I've found some billet top hats with AN fittings, (https://otakugarage.com.au/product/b...yline-r33-r34/) but wondered if there was anything else. And trying to avoid just using a couple of inches of rubber hose to bridge to the barb

    Cheers!

  2. #2
    Guest
    Join Date
    Jun 2009
    Location
    walsall/tamworth
    Posts
    6,744
    Rides
    0
    use a bulkhead fitting

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •