So after much looking for months there is no good online guides IMO, showing the relocation of the engine fusebox to the passenger airbag location.
Here's my attempt;
First remove dash (plenty post on this), unplug and label all connectors in the drivers side engine bay loom and fusebox.
Disconnect large square white block connector and the majority of plugs under the steering wheel/drivers area.
Pull/fight the connectors through the hole in the wing where the loom normally goes through and gets worn away when you go LOW.
Set the loom/fusebox out, unclip the fusebox housing and set to the side for cutting later if your not making a custom holder.
Then we should have something like this.
[IMG][/IMG]