Hi all,

First post in quite a while...

Currently I'm in the process of moving from a FMIC to a HMIC but I've hit a snag in regards to space for my turbo intake pipe.

I'm looking to remove the OEM PAS Banjo (which takes up a lot of room...) and replace it with an M18 -AN6 + 90 degree fitting to free up a bit of space.

Now my issue is I'm not sure where the restrictor is on my PAS system..... the kits I'm finding online to do this mention an M18 restriction bolt as seen below:




However, my car appears to have a "stud and bolt" on the banjo set up, so I'm a little confused as I can't find any info on this.


Would I be correct in assuming that the restriction on my PAS setup is built into the PAS stud rather than having the banjo bolt? or do I have to extract the stud and use the banjo bolt?

Any help would be much appreciated!

Cheers,
Ed