Just on the off chance has anyone replaced their prop centre bearing lately?
Mine is in need of replacement and was wondering where to either take it to have it replaced or to buy and replace it myself.
Just on the off chance has anyone replaced their prop centre bearing lately?
Mine is in need of replacement and was wondering where to either take it to have it replaced or to buy and replace it myself.
Fairly easy enough to do, will have to split the prop in half, undo a big nut with an impact gun on the front section of the prop and off you go.
Sent from my iPhone using Tapatalk
ahh thanks for that, I was hoping it wasn’t going to be a bugger of a job.
I just need to find the part number and somewhere that sells it now.
Sent from my iPhone using Tapatalk
Ahhh thanks man, I was kind of swaying towards a new unit to only go through the trouble of changing it just once.
Sent from my iPhone using Tapatalk
They're not unique to the s13. From memory it's still in use now, 4wd qashqai rings a bell.
37521-41L25
There you go, loads of OEM spares available.
Last edited by alanjuggler; 15-12-2019 at 21:44.
white '94 s13 200sx scrapped - mapped to 1.45bar. OS giken box, garrett GT2876R, 950cc injectors, ORC twin plate, nistune. 349bhp/325lbft @ 1.3bar CA18DET
white '96 s13 180sx - type g with more kouki bits - RB25DET, GTR steel twin turbo conversion, RB26 crank & rods. 2.6L VVT twin turbo, SR20 OSG box, OSG STR twin plate clutch, Z32 ECU w/ nistune.
current status: 180 a bit broken but to be repaired.
Yea brilliant thanks for that, I’m sure that answers the questions of quite a few gents on here.
I shall get one ordered up and I’ll change it out the same time I change the gearbox gasket and input seal.
Top man
Sent from my iPhone using Tapatalk