I came across this “barn find” when I asked a mate what had happened to his old car, It appears that after he blew his engine he decide a complete rebuild was in order and due to the shell starting to rust he would rebuild it all into a new shell.
To that end he got hold of a part stripped non runner with a good shell, he then collect a load of parts to do the conversion, rented some space in an old barn to keep everything dry and planned to start the project at a later date, It appears that the later date has still not arrived, I bought the whole lot from him with the intention of finishing what he started, I missed out one very important factor in my calculations, yes the wife, now she is very understanding but the line was drawn and apparently a total of 6 cars, (3 projects) was slightly past the line lol.
I am a member on the 350 owners and Docwra is also on there so I mentioned to him I would rather it went to an enthusiast rather than a just on eBay where no doubt someone will buy it just to split and make money, I can’t stop that but hopefully someone is actually looking for something like this and as the previous owner was a member here I thought I'd post here first before the others.
I am therefore looking to pass everything on to someone who either doesn’t have a current project or an even more understanding wife than me.
Not sure if it should be a car or parts as it is sold as seen for spares or repairs, viewing welcome.
The Cars –
1990 S13 Stripped out rolling shell – interior/engine all stripped out. It still has standard brakes and suspension. Most of the stripped-out parts are with it. No seats, the wiring loom has been cut out and there is no engine or gearbox in the car currently. On inspection I can see that the shell has had some sort of damage to the front driver’s side most likely an accident that has been repaired in the past. There is some rust in it and there are some rust repair patches also from some point in it’s past, It is not immaculate but could be brought back, remember it is nearly 30 years old!
1990 S13 “Donor car” – The bottom is very rusty! IMO it is just a parts donor and not worth any attempt at repairing. The fully forged engine that blew has been removed and a standard engine put in, We put a jump pack on it as the battery was obviously dead after 9 years, it started (on 9 year old fuel) it still had oil and water in it, The clutch was not working but in the spares we found another master cylinder which we swapped in and it now drives as well. It is what you might call “track ready” most of the rear interior is stripped out and most of the dash does not work. It does have a few redeeming qualities though –
Full aftermarket Intercooler and pipe work from when it had a bigger turbo and forged engine
5 stud hub conversion with big brake kit from either an S14 or an early GTR the original owner can’t remember.
Front and rear strut braces
quick shifter (unconfirmed)
Loads of aftermarket dials (none appear to be wired up anymore and are untested)
Ally Rad I assume it has an aftermarket fan.
Mapped ECU.
Alloy Wheels (not 200sx)
The Parts list –
Full body kit – New + 30mm Front wings, +50mm Rear wings, side skirts, front and rear bumpers. I unpacked them for pics.
Daiyama suspension set – New and still boxed
Full exhaust system (stainless only used for 1 month according to original owner)
American spec rear lights – Used with mark in centre section
Steering Wheel – New (eBay special?)
Quick release boss – assumed to fit 200SX
ECU upgrade chip – New
Mechanical boost controller – New
Oil cooler – New
Oil sandwich plate/relocation housings – New
Oil sandwich plate – Used
Bolt in roll cage – New
Quick Shifter – New
Polished covers – Not fitted since polishing
Front and Rear strut braces – New
Turbo Manifold – New This is nice!
Red Alloy Wheel nuts – New
Washer Bottle – New
Silicone Hose set – New
Spare set of 4 Alloy wheels – Used 18x8
Greddy Boost Controller – Damaged screen untested
Blue lightweight Pulley Set – New
Cam Covers blue and red – Used
Toyo intercooler and pipes – Used
Forged Rods – New, no branding
Cusco catch can – Used
2 x ECU’s with different maps – Used
2 Turbos with one manifold and first section of down pipe – Used
Clutch hose – New
Another large turbo. (3 turbos and 2 manifolds in total)
Stainless Downpipe – New
2 x spare gear boxes (untested) both with quick shifters
One spare engine – believed to be a non-runner
Spare diff – believed to be welded
Boxes and boxes of standard parts assumed to be from the stripped-down shell.
Looking for £3,500 or near offer (the quicker you can collect the more negotiable I am)
This is collection only and both vehicles will need to be trailered away and you'll need a BIG van for the rest of the parts.
A few pics - For more pics or questions drop me a PM.
Cars -
Parts -
Click on any pic and scroll through the album - I'll post more in a mo on here though.