-
Guest
Front lower control arms
Ball joint is worn quite badly on my nearside lower front control arm, now I am going to replace them both with Driftworks adjustable arms, will these just simply fit into place without anything else as my car failed an MOT because of this.
-
Guest
You'll need them fully aligned and to be honest when I had a set I wasn't impressed with them. It'd be a lot easier and cheaper to to push in new ball joints if you don't need the adjustability
-
Guest
As above I’d fit new new ball joints in yours will be easier you will want an alignment either way
but if you do go with new arms let me know if you wanna sell your old ones
-
Guest
Rock Auto should be able to sort you out with a pair of new arms, bushes and balljoints pre-fitted.
CamSkill used to do em over here, but stopped selling alot of stuff
-
Guest
Okay just ordered the driftworks arms.... how much on an average do you think it will cost for a garage to fit both arms?
-
Guest
Fitting is relatively cheap, it's the full alignment job that will set you back a few hundred quid.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules