So basically I read that a few people have replaced the standard clutch line for a braided one and had good results, I thought I’d do the same as I can see my rubber hose is trying to expand when I press the clutch.
So I’ve removed all the old stuff carefully, there was like black residue in the master cylinder so i sucked the out and cleaned it up inside, fitted the braided clutch line (from master to slave) filled the master with fluid, now I’m trying to bleed it but getting nothing at all out the bleeder on the slave? Just lots of air and little spits of fluid?
Have I screwed up? Is there anything I can try? The clutch was working fine before, it has an uprated clutch (not sure which one) but the clutch pedal was nice and hard before, now it just stays on the floor, any advice would be very much appreciated, I’m slowly giving up with this car!
Sent from my iPhone using Tapatalk