-
Guest
-
Guest
It has been great. Could you explain the process a bit?
Last edited by acp calsonic; 12-09-2018 at 18:39.
-
Guest
Yeah it’s pretty simple but being the first time I’ve done it I’m far from an expert on it but here goes
Sand the plastics with a corse sand paper
Mix up some epoxy and paint it onto it and leave it an hour to go sticky
Cut out some bits of carbon and lay it onto the plastics and trim as best it leaving some overlap
Push the carbon as best you can into the shape
Mix more epoxy and put just enough on to wet the fabric and no more
Cover it in perforated release film and breather fabric
I used big sandwich/ziplock bags and pull a vacuum and leave it for like 5 hours
Peel all the consumables off and trim with a dremel
Sand the big defects and scuff the surface up
Mix more resin and put a coat on then leave an hour and put another coat on
Sand it nice and flat
Paint with clear coat
That’s how Ive done/doing it anyway
-
Guest
-
Guest
-
Guest
-
Guest
Nice work. Have you had a chance to fit any of them yet?
-
Guest
Sent from my iPhone using Tapatalk
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules