Hi guys.
I've had my ps13 around a month or so now but a lot has changed already!
This is how I got it:
138000 kilometers
hks2540 turbo
z32afm
nismo 555s
cusco 2 way
paddle clutch
hpi intercooler
hpi airfilter
hpi hard pipe from z32 to turbo
arc alloy rad
tein coilovers
after market front tension arms
after market front hubs for extra lock
30mm extended lower arms
aftermarket track rod ends an track rods
all steering mods done in japan
50mm rear quarters
30mm front fibreglass wings
fibreglass bumpers
plastic side skirts
rocket bunny boot spoiler
red an clear back lights
cusco rear strut brace
hks boost controller
60mm boost gauge
nardi steering wheel
flocked dashboard an centre console
s14a leather front seats
18x10 et 15 all round rota grids
full stainless exhaust
hpi exhaust manifold
twin pipe down pipe
decat pipe
hks oil cap
short shifter
dildo gear knob
project mn brake pads all round
r32 gtr front discs an calipers
rear locking collars
And it looked like this
When I got it the heater didn't work. It took a bit of research and trial but I finally realised I was missing the ambient air sensor (with help from nlrfy) and got one ordered (this allows the actuator arm to adjust the heater box) and got that sorted so was a nice tick off the list!
I'm not sure what blue This is but I've seen another ps in a similar colour. It's lovely with a nice metal fleck to it in the sun! Unfortunately I've changed a fair bit already to achieve what I'm after so it will be changing soon.
Here's how it currently sits:
I bought some lovely wheels. Knowing full well they won't go straight on, so ordered some +55mm origin type 3 front wings from Ireland to help the fitment issues.
The wheel specs are:
Works rezax,
Fronts - 18x10.5 et-24
Rears - 18x12.5 et-10
......yes, they're wide! Haha
So anyway I realised the coilovers I had would not go any lower without any ghetto mods so decided to pick a set of rears up to help set my ride height to where I want it. They're only cheap eBay coils for the back but they will help me get my ride height and body work sorted for now and I will get something of better quality on in the future, although I feel if these had a stiffer spring they wouldn't actually be too bad!
So here is how it sits with new rear coils on nice and low where I want it! Excuse the crap pic it's a screen grab from a video.
As you can expect with such aggressive fitment up front I had some arch clearance issues...
So off it went to my mans workshop for tubs. I stripped the front end out ready for him and he did some cutting and welding and ended up with this
Obviously as some of you know there's some other work involved with this set up..... but I have clearance now and got the car home again.
So to do currently is:
• relocate power steering reservoir
• relocate engine loom/fuse box
• do some fancy painting in the bay to clean it up
Amongst other things I have trimmed my door cards as they weren't in amazing condition to suit the flocked dash. It's not to everyone's tastes but I like it and it's a bit different. It's a crushed velvet velour and cost me under £20 to do
I've also recently put my bride revs recliner in too on a bride sliding rail and am in the process of finding some interior plastics.
I also have started my sticker collection as I love them Haha, and I've just released my own slaps too as seen on my photo (I run dodgemsquad still)
Hope you all like it and if you want to see shenanigans relating to the build and other stuff I'm doing follow my Instagram @dodgemsquad and my Facebook page www.facebook.com/dodgemsquad
Let me know what you think!