Results 1 to 4 of 4

Thread: Cannot get sr20 box off

  1. #1
    Guest
    Join Date
    May 2006
    Location
    wirral
    Posts
    2,676
    Rides
    0

    Cannot get sr20 box off

    Been helping my mate get the box off his 180 redtop project all the box seems to do is spin wont fully separate any tips???

    Both box and engine are out the car on his unit floor he never put them together but alot on this cars been built by a idiot (wont name and shame)

  2. #2
    Guest
    Join Date
    Jun 2009
    Location
    walsall/tamworth
    Posts
    6,744
    Rides
    0
    sounds like you are going to have to get a pry bar each side of the belhousing/engine gap and 'walk' it off.

  3. #3
    Guest norfy's Avatar
    Join Date
    Jun 2008
    Location
    Ashford, Kent
    Posts
    1,283
    Rides
    0
    itll be grabbing on the spigot bearing. Worth checking that it hasnt had a pull type clutch fitted as well, could need that releasing first.

  4. #4
    Guest
    Join Date
    Jun 2012
    Location
    NW, England
    Posts
    1,761
    Rides
    0
    It is possible it shouldn't spin if butted up to the engine. Should it have dowels so the gearbox lines up properly?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •