-
Guest
Removing T28
Going to do exhaust side gaskets soon on ca18det and curious if anyone has lifted the engine out slightly to get better access to manifold nuts? Would it make this pita job abit quicker?
-
Guest
I did the bottom rear one with a 40cm long spanner. Made it "easy". The rest are simple.
-
Guest
T25 has lot more room to play but with t28 i cant access anywhere near from under, cant imagine putting the nuts back on after
-
Guest
I did it with a T25 recently and I can tell you if you don't have braided water/oil lines yet you might as well pull the engine out 30cm. It would take you the same time, I swear. But if you don't have an engine hoist and if you already have braided lines then fiddle from bellow.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules