-
Guest
Nissan front wheel speed connector?
Has anyone managed to find it new for reasonable money?
Any idea who makes the connector?
For S15, but I guess S14 and maybe S13 use the same connector
Like this:
Last edited by immy21; 09-05-2017 at 16:48.
Reason: Wrong connector
-
Guest
For the abs sensor? Do you need new sensor or connector?
Sent from my iPhone using Tapatalk
-
Guest
ABS sensors yes, Either or.
Basically, bought geomaster 3.
Don't think I can remove original s15 sensors, (tried before in my s14 and destroyed them) so prefer to leave them intact so can sell s15 hubs with sensors.
I bought Pug 206 sensors as per Bigjoe thread, planned on crimping on my own connectors both ends however difficult to access harness side.
So, If I can find male ABS connectors as pic, I can simply put them onto the Pug sensors, and bolt everything up.
That's the idea anyway.
-
Guest
These look similar?
https://www.ebay.co.uk/itm/252828406132
If not I use these
https://www.ebay.co.uk/itm/401306009574
Or when I need silly things like that I message Paul at banzai breakers, he's normally very helpful and sends them out
Sent from my iPhone using Tapatalk
-
Guest
Iv got plenty of the 2nd link and was plan A but it's not easy to access the harness side for a good cut, strip and crimp
As for the 1st link, look similar but if its goin to cost £30ish delivered for 2 connectors, il make plan A happen
Cheers for looking though
Last edited by immy21; 09-05-2017 at 19:17.
-
Guest
Oh, il contact banzia breakers thanks
-
Guest
Go to breakers, find pug 206 and cut whole connector with loom wire off. Splice to your loom. Tape up over splice.
-
Guest
I ended up using superseal style connectors both ends.
Once hot pipe and harness clips were removed access was fine.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules