-
Guest
Why not just get a 1/8 bsp to an3 adaptor and tap it into your thermostatic plate on the pre cooler side and run a section of an3 braided brake pipe to the sender
I've used an m10x1 femsle socket and forced the 1/8npt sender into it with some sealer and it's never leaked as there almost the same and that's been done on 2 cars for a total of 6 years
-
Guest
Good idea but the idea of swapping at the stock location is mostly because there is no need to take anything apart. If it's really 1/8 bspt there shouldn't be any problem, I guess I must have gotten the wrong adapter.
I'll get another and try again
-
Guest
im sure NPT tapers in at the end, so if you look at the thread from the side it will be a cone shape..
-
Guest
It's been done before by a couple of people, I'm pretty sure there are threads on here or Driftworks?
Have you sent those people a pm, see if any of them respond?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules