-
Guest
Apex type 2 fmic nipped for vacuum pipe
Hi, bought one of these off the forum but now notice that pipe is welded where normally there should be a nipple for the vacuum off the solenoid to go into.
Anyone any ideas why? Not sure where to put the vacuum pipe now.
Thanks. Navi.
Sent from my E6553 using Tapatalk
-
Guest
-
Yorkshire Rep
Just buy a boost nipple from ebay and put that in the coupling between the inlet and intercooler piping.
Drill a hole in the rubber, put nipple in, put the rubber seal on the back then the nut and then tighten the nut with a spanner. Run hose from nipple to solenoid.
-
Guest
Cool. Just couldn't understand why the original is welded up. Must be a reason for it.
-
Guest
Previous owner might have been running from a nipple on the plenum.
-
Yorkshire Rep
Yeah as Jonny says, it doesn't ultimately matter where you run it from. Removing the charcoal canister usually frees up a vacant nipple on the plenum for example.
Horses for courses
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules