Results 1 to 4 of 4

Thread: s13 with s14 engine conversion - temp Q

  1. #1
    Girly rep Neelie's Avatar
    Join Date
    Feb 2009
    Location
    Ireland
    Posts
    1,501
    Rides
    0

    s13 with s14 engine conversion - temp Q

    my jap sr20de s13 got its s14 vvt sr20det fitted and the water temp gauge isnt working.
    i gather from google that there is a wire that needs to be changed for it to work on the s13 loom...?
    is that correct? does anyone know specifically what wires and where?
    thanks in advance

    (PS: yes its plugged in proper, and no i don't want and aftermarket gauge thanks )
    "If you don't fight for something, you'll fall for anything" - The Wise Man

  2. #2
    I <3 BBS LM Actual_Ben_Taylor's Avatar
    Join Date
    May 2001
    Location
    South East
    Posts
    23,353
    Rides
    0
    Is it not just the sensor that needs swapping over to the S13 one?

  3. #3
    Girly rep Neelie's Avatar
    Join Date
    Feb 2009
    Location
    Ireland
    Posts
    1,501
    Rides
    0
    no it was an sr20 na that was there before and told they were the same, its actually the s13 wiring to the dash that has a colour thats different und just needs to be joined to something else... something or other lol
    "If you don't fight for something, you'll fall for anything" - The Wise Man

  4. #4
    Guest
    Join Date
    Jun 2009
    Location
    walsall/tamworth
    Posts
    6,497
    Rides
    0
    to test to see if the sender is faulty try unplugging the wire off the sensor, then hold it against the engine block. grounding it out will make the gauge rise all the way to the top.

    although it sounds to me like you need to swap a pin on the dash interface plug (m54)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •