Gearbox Input shaft bearing.

[Daz]

Anyone changed this before? Before my car came off the road the input shaft bearing was making a noise and there's a bit of play in the shaft now so before I put it back in the car it would be good to replace this bearing.

Anyone done this and know where to get the bearing from?

[green_rs13]

its easy enough to change. take the box off the car. then take the front cover off from inside the bell housing.then take the giant circlip off.

[enzo]

its easy enough to change. take the box off the car. then take the front cover off from inside the bell housing.then take the giant circlip off.

I needed a press to remove the bearing, as it's pressed on to the shaft.

I stripped the whole box though, but you may be able to use a puller if you leave the external snap ring in place and you can get a bit of purchase on it. Not sure though.

http://simplybearings.co.uk/shop/adv...s=63062rsnr-mb

This is the bearing, and where I got it from.

[Daz]

its easy enough to change. take the box off the car. then take the front cover off from inside the bell housing.then take the giant circlip off.

Cheers dude. Managed to find a guide on it which is really helpful .

I needed a press to remove the bearing, as it's pressed on to the shaft.

I stripped the whole box though, but you may be able to use a puller if you leave the external snap ring in place and you can get a bit of purchase on it. Not sure though.

http://simplybearings.co.uk/shop/adv...s=63062rsnr-mb

This is the bearing, and where I got it from.

Thanks for the link. I called Nissan earlier and they wanted £48 for the bearing. I've ordered the one from that link so fingers crossed.

[Desa]

Easy job to do it, i would recommend to change front cover gasket and oil seal too when reassembling all.

Btw i couldnt reply you, your pm box is full


Sent from my iPhone using Tapatalk

[Daz]

Easy job to do it, i would recommend to change front cover gasket and oil seal too when reassembling all.

Btw i couldnt reply you, your pm box is full


Sent from my iPhone using Tapatalk

Could you get some prices for the front cover gasket and oil seal. Didn't realise my inbox was full. I'll clear some space.

[JuicyCarbonFX]

Daz give us some links mate, I have a spare box here in need of that bearing I should like to replace it and have a spare box that dont sound like a bag of crap lol

[Daz]

Daz give us some links mate, I have a spare box here in need of that bearing I should like to replace it and have a spare box that dont sound like a bag of crap lol

This is the one I've found http://www.subituned.com.au/forums/i...owtopic=519917

[JuicyCarbonFX]

Thanks for links, I shall set my stop watch and see if i can beat 9 hours lol

[Daz]

Mine should be quicker as the gearbox is out of the car already lol.

[Mark]

This is the one I've found http://www.subituned.com.au/forums/i...owtopic=519917

Is that cowboy corner

If you want the bearing pressed off let me know.

[Daz]

Yeehaw lol.

Once I get the new bearing I'll strip the box and remove that shaft. Can fit the remaining engine parts too then .