I thought i would also post this here... as its generally more active that the Skyline forum. But its RB, not SR!
-----------------------------
Hi guys.
Finished my S14a - RB25 swap, and im left with some vacuums i've bunged off with bolts.
Currently im getting no boost or rev over 4k RPM. Im pointing blame at my vacum hose plumbing. Can you guys have a look at the images below and identify what's what?
Engine is from a R33 GTST and bog standard until it runs right before i'll modify. Only thing it has is a FMIC, 3' Exhaust, and a air filter with a MANUAL boost controller.
#1 - On the throttle body? - Where should this go?
#2 - Rear of the inlet manifold. Tiny little one. - Boost gauge source.
#3 On the standard Recirc piping.
Then this is how iv got my manual boost controler and standard re-circ valve plumbed in. Which i think isn't right?
Basically. She will run, idle and drive but only up to 4k rpm. Its like a wall anything more.. and it wont rev and dump etc.
Scratching my head on this one! :bash: