Struggling to fit NRG Slim Boss

[kennyx]

Maybe this will help
https://youtu.be/FDU3MoxMzYM

[shifty babe]

I've done a bit of research and it seems the ones that fit a s13/s14/s14a won't in fact fit a S15.

I'll be returning it and most likely buying a works bell as there doesn't seem to be much else available that S15 specific.

[agentsmith350]

Been offline for a while , Coming back to this the seller completely fobbed me off until the claim time on paypal had passed then ignored me.

Ended up re drilling the back end of the hub to fit the indicator cancellation ring , AVOID ZENO RACING

[R3K1355]

Yea buy from an authorised dealer dude.

[Daz]

You have to remove the clock spring. See my post here - http://sxoc.com/vbb/showthread.php?4...=1#post5173588

[nash`s]

i ran into a few of these problems when i purchased an nrg slim hub. seemed like a lot of hassle getting everything to fit and wasn't keen on the horn design too. bought a works bell short hub instead and its a much better design, indicator delete works fine, spring clock can be left in place and they also supply a resistor to cancel out the flashing air bag light.

[agentsmith350]

Clock spring was already gone daz , the 3 holes for the cancellation didnt line up at all

[agentsmith350]

Thanks Nash , Might switch to a Works one at some point