Brake line help

[budgieee]

Hi guys
So when fitting coilovers to the front of my s14a, the metal brake line out of the back of the caliper snapped so I have bought a set of driftworks braided lines as replacements .
But now run into a problem . Where the rubber pipe meets the copper pipe farther up it is very carroded and looks fragile. I've tried a set of vice grips on the nut, but it's not budging. Does anyone have any tips on how to get these separated :S and would it be worth replacing the whole copper pipe? Thanks

-Alex

[Desa]

Hi guys
So when fitting coilovers to the front of my s14a, the metal brake line out of the back of the caliper snapped so I have bought a set of driftworks braided lines as replacements .
But now run into a problem . Where the rubber pipe meets the copper pipe farther up it is very carroded and looks fragile. I've tried a set of vice grips on the nut, but it's not budging. Does anyone have any tips on how to get these separated :S and would it be worth replacing the whole copper pipe? Thanks

-Alex

Heat it with blow torch and then try again it usually helps

[budgieee]

Heat it with blow torch and then try again it usually helps

will do. stupid question, but is brake fluid flammable ?

[kingk]

I put the spanner on it then tapped it with a hammer until it "cracked"


Sent from my iPhone using Tapatalk

[immy21]

Flare nut spanner.

http://pages.ebay.com/link/?nav=item...d=131552119027