These are just off ebay Jonny. I think a tenner a belt!Originally Posted by Jonny Wilkinson
These are just off ebay Jonny. I think a tenner a belt!
Fair play missed this, just looking through and im impressed with the front crossmember replacement.
Keep it up fella
Cheers Nick! Got loads more progress to post up!!
Lots of progress to upload but here some since the last time I posted.
Bought myself all the parts for a stage 2.
Turbo - Garrett T28 (zero play either side) modded to fit an S13 with nipple and compressor rotation.
Apex Braided water and oil lines
Owen Developments actuator
All new gaskets
Stainless elbow to fit S13 Japspeed exhaust.
Fitted my FMIC, if any one seen my help thread there is more progress pics of the making of the bracket. Slightly over engineered than what it needed to be, but its on!
I will need to adjust cold side pipe work as its touching the chassis and I'm thinking it will ware through eventually!
I have all the other parts for stage 2 including a 255lph fuel pump, plugs to suit, etc.
I purchased a rear bumper today also.
Apparently its a genuine BN Sports rear bumper. I'm not fussed either way as I was going to buy a replica kit anyway.
(Pictures are from the seller, I'm not fortunate enough to own a playhouse!)
I also repaired the rear boot from the nasty holes which were in it previously.
The wipe hole has been deleted and also the rot and spoiler bolt holes.
Before
After
There was a lot of rot on the edge, the before picture is quite flattering actually!!
What make is the FMIC?
I like the bumper,are you going full bn kit or going to mix kits to suit?
The gent I have purchased the rear bumper from has potentially got some real URAS side skirts which need a repair. I prefer the URAS as they are more flaired than the BN ones.
Then I'll purchase a replica BN Sports front bumper if I can't source a real one at a reasonable price!
Last edited by adamwhy; 30-09-2014 at 15:00.
Posting Permissions
Reply With Quote
