Pic request - RB25 S14 radiator mounting

[handsomedez]

I'm trying to work out where my radiator is gonna fit in the bay, but won't be trial fitting the engine for another few weeks. So far I've chopped about 4" of depth from the slam panel and chopped about 2" out of the bottom radiator mounts (S14) and welded them up again. These bolt to the lower crossmember.

If anyone has done all this before could you post a pic of fitment please. I've read about folk cutting the crossmember to get the radiator far enough forward. I'd rather not do that if I can help it, but at the same time I'm not gonna compromise the radiator for the sake of a bit of cutting and welding.

I've got an R34 GTR 52mm alloy radiator, and I want to keep either the RB or SR viscous fan. I'll fit electric push-fans on the front of the radiator.

[dannyboi200sx]

I chopped mine up and used Evo 4 fans

[handsomedez]

I chopped mine up and used Evo 4 fans

Did you chop the crossmember? Might just chop a couple of inches out of mine then I know I'll have plenty clearance.

[dannyboi200sx]

Yea