Results 1 to 2 of 2

Thread: Audi origional 18"x8 alloys (mint)

  1. #1
    The Welsh Whinger! pdh 14a's Avatar
    Join Date
    May 2004
    Location
    Swansea
    Posts
    24,625
    Rides
    0

    Audi origional 18"x8 alloys (mint)

    Got these for sale.sounds like they are off an audi a4 B7 cabriolet or similar.lovely fitment for an S4, S3 etc.pic of them on my Altea was with no spacers!
    They are immaculate with no kerbing at all,just 1 very small mark pictured,and a small bit of corrosion on the rear of some of the wheel arms!
    Also the tyres are down to the wear markers,apart from 1,but this has 2 nials in it.
    *So If posting,i will probably remove the tyres*

    They are 18x8 et43 centre bore 57.1

    I'm after £450 collected.I am near Swansea,but may be able to meet at Cardiff or 50 miles nearer you!















    Last edited by pdh 14a; 17-01-2014 at 10:48.

    You only need two tools in life - wd-40 and duct tape. If it doesn't move and should, use the wd-40. If it shouldn't move and does, use the duct tape.

    And if you can't fix it with a hammer,you've got an electrical problem!

  2. #2
    The Welsh Whinger! pdh 14a's Avatar
    Join Date
    May 2004
    Location
    Swansea
    Posts
    24,625
    Rides
    0
    bump! £400 to any member on here

    You only need two tools in life - wd-40 and duct tape. If it doesn't move and should, use the wd-40. If it shouldn't move and does, use the duct tape.

    And if you can't fix it with a hammer,you've got an electrical problem!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •