Which port goes to actuator and which goes to hot pipe?
Thanks!
Sent from my C6603 using Tapatalk
Which port goes to actuator and which goes to hot pipe?
Thanks!
Sent from my C6603 using Tapatalk
It may depend on what boost controller/ecu you are using.
Have a look at the AVCR instructions, around page 40 onwards (of the pdf, rather than the actual page number, page number is 38 onwards)
http://bagpuss.swan.ac.uk/200sx/apex...C-R_manual.pdf
Thanks! I have a profec b if that helps?
Sent from my C6603 using Tapatalk
I expect it'll be the same, searching around it's the standard setup for actuator based setups.
Try it, see what happens; but go easy and watch your boost gauge.
My guess is 2 to actuator and 3 to hotpipe. 1 to air.
Looking at the diagram on it. Spring valve position would give hot pipe pressure to the actuator. Solenoid activated position valve would connect actuator to air.
thanks guys!