Will front ABS sensors from Skyline (R34 2.0 NA) work on a S13?

[MeSs]

I'm currently restoring a S13, while trying to get the ABS sensors out of the front knuckles, both was damages
I have found the sensors in the US for 650usd, but my friend has a Skyline R34 thats a built drift car, with mint ABS sensors that he's not using.

I havent tried to fit it yet, but here is a picture:
http://db.tt/g3mK4YiA

The contact is different, the diameter seems to be almost the same.

[Actual_Ben_Taylor]

I'd be 99.9% certain they'd work

[Jonny Wilkinson]

S13 sensors are gold dust. As you found, they don't come out in one piece.

If you've got a set from an R32, its worth a try.

If your MOT is still a way off and you are determined, you might get a set off a 180SX as they will definitely fit. 180SX sensors tend to come out whole as they haven't seen as much salt as UK S13s.

Most folks just delete the ABS but it needs doing right for the MOT.

Alternatively, look for a set of hubs with the ABS sensors included but make sure they have disconnected the sensors at the connector inside the inner wing and not just cut the wires

[MeSs]

Thanks for the reply guys.

[skyshack]

Skyline R34 thats a built drift car, with mint ABS sensors that he's not using.

I havent tried to fit it yet, but here is a picture:
http://db.tt/g3mK4YiA

The contact is different, the diameter seems to be almost the same.

I don't think they will work. The S13 tip is longer and has a chisel edge pointing at the toothed wheel. The tip needs to extend all way across the tooth.