Hey all,
This has probably been covered before, but I can't find it in the search (I maybe being blind).
Who's running stage 3 on a ca??
And what mods (apart from standard stage 3) do you have??
So looking at clutch etc.
Cheers
Hey all,
This has probably been covered before, but I can't find it in the search (I maybe being blind).
Who's running stage 3 on a ca??
And what mods (apart from standard stage 3) do you have??
So looking at clutch etc.
Cheers
Nobody running a ca on stage 3??
They probably don't understand the question. I don't
Maybe the op is looking for a clutch that will take st3 powers, if that is what you are looking for check out the linky:
http://www.sxoc.com/vbb/showthread.p...remaining-kits!
I got a st4 comp clutch on the above thread, more than I will probably need but better to over spec than under. Hope this helps.
Last edited by foghorn leghorn; 24-06-2013 at 13:20.
for no real reason a lot of people seem to struggle getting a stage 3 setup to work on the ca. i know a few folk who ended up going back to stage 2.
not that was a while ago so i dunno if anything has changed.
as for clutch
exedy hyper single is a good call. Kev has been running his for about 4 or 5 drift seasons at 360+bhp on a stroked ca and it's still going strong
Hi mate.
I'm running a stage 3. Good upgrade if done right.
Acl main and big end bearings
Gapless rings
Gt28 turbo rebuilt with 360 bearing and tapered seals
Cosmetic gaskets and mls headgasket
Stainless 316 manifold and straight through stainless system.
Z32 maf
Horsham dev stage 3 chip
Manual boost controller
Front mount intercooler
Big 444 injectors
Walbro fuel pump
Solid engine and box mounts
Braided water oil clutch and brake lines
Hks filter
Blitz blow off valve
Exedy clutch with short shifter
Blitz turbo timer