Hello Lads,
Here for sale i have my S13 project which was bought as a rolling shell about 6 months ago the car then went straight to Slough to have a engine and box fitted by a qualified Garage-D technician. the car is nearly there just needs a few little bits to finish it off all the hard work has been done, the shell is basically rust free now very tidy shell fully under sealed including gear box tunnel so the underneath is immaculate. specs as follows :
CA18DET 73K on it very healthy no knocks or bangs etc,
Gear box is low mileage was inspected before fitting all teeth etc are fine
T28 Turbo (genuine Garrett) again low mileage turbo boosts well
Apex front mount intercooler (needs piping) side mount fitted at the moment.
Walbro 255 Fuel pump
Nardi wheel
5" Angled Unknown brand Straight through exhaust
6 - Point bolt in Cusco?? through dash very clean cuts, Roll cage painted fluro pink at the moment could do with a few more coats though.
BK Racing 17" wheels need Refurb and rubber, rubber on the wheels but not legal
Carbon wrapped door pillars, was going to do the boot and bonnet at some point but never got round to it
Car has just had as much rust as i could find removed i've checked pretty much everywhere, the car does need some welding in spots however i've had a quote from a local welder who agreed a cost of £120 including him providing the steel to do the work, the rear has been completely stripped out and ive spent so many hours prepping it for paint ive lost track. as i said the car needs a few parts to get it road legal it needs the following off the top of my head,
- Rear brake lines, they have been cut right at the calipers so its a easy job can get the kit to do it for £13
- Drivers seat, comes with s14 leather passenger seat though.
- power steering line needs replacing same scenario as the brake lines again a cheap fix.
- bumpers
- cluster for some reason is not working properly, may aswell just get a new one considering they are only around £20
- rear lights.
All electronics are working properly as are lights that are present all heating etc works,
Pictures :
Bits that need welding
as you can see its a clean shell just needs a bit of attention to get it back on track, ive done all the worst bit's just needs a final push to get it finished, the only reason im not keeping it is because i saw this and fell in love with it :
if it wasn't for this car i would of continued the project and finished it and used it for my daily, its a clean shell and if it wasn't i wouldn't have gone to the effort of transporting it all over the country to get it to where it is now
it owes me at least £1700 plus the amount of hours ive spent on it getting it rust free.
however
£1400
as it stands.
thanks Jake
Reply With Quote
Have you bought that?
Originally Posted by S14 Stu
sorry, I'll move on now....GLTWS