-
Guest
What does your gizzmo boost controller say ? sr20det.
Need advice please
Done an sr20det into s13, fmic, fbu, pump, air filter, 3"exhaust, Gizzmo ibc, catch tank.
Wondered what readings peoples gizzmo IBC said to them from 2k revs and through to red line. Mine doesnt zero (0.0) until im at basic idle revs, but will stay firmly at 0.2 at a constant speed, revs at 2k with no acceleration.
Max boost is 0.7bar.
Does this sound right?
-
Guest
Normally you'd be reading a minus figure (vacuum) at idle on an EBC and probably still minus at 2k cruising along with no load.
-
-
Guest
Mine reads 0.00 on idle and just goes up to max boost its set at. It doesnt sit at any other number
-
Guest
when does your boost start to cut in? , not sure why mine is doing this, any ideas? It doesnt over boost.
-
Guest
Mine reads 0.00 on idle. I guess if there's no boost to read it will say 0.00 until boost starts. I've got a 2871r with .86 rear housing which gives me boost reading at 3.7k when it starts to boost
-
Guest
what everyone else said - Zero until boost kicks in.
-
Guest
So the Gizmo doesnt read minus then! Great, i have one to fit into another car here. thought it would have done.
-
Guest
Why doesn't it read a vacuum? Just fitted a blitz SBC ID that I've had for years, (was fitted in my old MR2 T), and that reads minus figures, thought all EBC would?
Alex B
-
Guest
mine does this on the odd occasion, ive not found what it is.
i find if i stop, switch off, and start the car again. it resets the reading to zero. doesnt do it often, usually only when ive come from a prolonged boost session...
-
Guest
Unless theirs are not plummed in after the TB? If it was before then it wouldnt see vacuum.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules