Looks good bud.
Its amazing how many bits i can spot on there that used to reside in my shed lol.
Get some up with the new wheels - we still need to work out the spacers needed.
Cheers
Looks good bud.
Its amazing how many bits i can spot on there that used to reside in my shed lol.
Get some up with the new wheels - we still need to work out the spacers needed.
Cheers
hello guys,
been a while done so much heres abit of an update
where do i start...
took the bonnet off so i can fit my custom made turbo from work, new pipe work and alu rad, braided clutch lines n much more
my turbo spec:
.60 A/R but comp cover been profiled to fit bigger comp wheel
All faces skimmed to new
69mm billet comp wheel that been fettled and glass blasted
ceramic ball bearing
bronze bearing carriers
stag gap piston ring
been balanced to perfection
.80 A/R turbine cover been profiled to take new shaft and wheel
all faces been skimmed to new
56mm GT35 Shaft and wheel with 7 deg cut back
Westgate has been ported and flowed
Adjustable actuator set to 1 bar
had lots more parts turn up
so got underway fitting and playing with this lot
then my new dails turned up
then found some fiberglass and bodyfiller so.....
then alt sized while going down the motorway with my alu pullys n killed it :-(
so at work when i had 5mins, i made a top hat insert,
then got carried away and made some rockercover bolts
after a while of getting more parts the time came to brave the cold and start fitting
got full set of adjustable arms, r33 rear brake set up, flexi decat, 50mm spacers, braided lines, 740cc injectors, z32 maf n more
got uprated arb from a gb of dan @ bd power,
now comes to fitting it all so i call in a few guys for a hand,
not saying a thing nath (redlinezak) and mark,
then moved on the to inside
also got new wheel and boss
tryed to fit carpet in the back not bad for a test run
fitted std rear light, now looks so much better with arches filled
fitting the aero catches
big thanks to all the guys who have helped so far and all the guys on sxoc for you advice and parts :-)
Last edited by ajmalins; 03-04-2013 at 19:46.
its already to be mapped so just got to save up but its abit hard when im trying to build the new engine for,
I bougth a rb25det so was in good nick and working but i got bit carried away in cleaning it now its all stripped and ready to be rebuilt
so far it looking like this (bear in mind only bought it on easter monday)
after quick clean and rubdown
now look like
now just got the hole lot to clean and rebuild
Last edited by ajmalins; 03-04-2013 at 19:45.
That pic of me and widgster was much more suspect than it looked
You owe me a new beanie btw as mine is now a dribbling melted mess after spending an hour with my head stuck in your arch lol.
Engine looking good mate will see you in a couple of weeks for round 2 of Man v Arch.
yeah yeah if you say so :-p
deal then its mapping time :-)
good liitle project and not to far from me either, have you been on skyline owners, for some parts?? I have the standard inlet manifold and the standard 'L' to the throttle body if you want it??
bit of an update,
got more bits for the rb,
sent the head off to be checked and skimmed, got the valves seated,
got the uprated bearing, took out the sr and running gear,
hid all the wiring and painted the bay
replace the subframe with the r33 one
cleaned and painted all brackets and parts
have a look