And where did I remove it from?
And where did I remove it from?
crank case breather pipe i reckon, under inlet, towards back of engine.
pretty important to be honest. lol
Negative, PCV is connected. This seems to be a water pipe but I've connected them all up!
put water through your engine and see where it comes out
LOL.
its one of the pipes near the back of the inlet. i remember seeing the ring thing on my engine. lol.
if it wasnt so bloody cold id go and take a picture
I remember taking it off the back of the engine but I don't know what it connects to.
goes to the heater matrix
That would make sense. Will have to check tomorrow. Thanks bud.
Yeah erm that's what I meant erm. Lol
I did go out and have a look, but couldn't get a decent picture on mine.
CA head with rear waterpipe fitted.
I have THAT one connected guys. In fact both the heater matrix pipes are connected. I'll have to double check.
Yep have it connected see.
Last edited by Tosseef Hussain; 01-12-2011 at 21:25.
that pipe connect to the AAC valve thingy... it passes through the intake plenum...
I tried that too but it didn't work. It just scratched up my paint on the plenum.
I'm almost positive that it is the hard pipe that runs under the plenum between runners 2 and 3, for the AAC solenoid.
A small help on the way.
SR Timothy Tréville
Chairman, Nissan Owners Group Sweden
`SHOGUN´ Project +700BHP CA18DET
Is it possible its a spare ?
I still think its the waterpipe that runs at the back of the engine for the heater matrix as stated above.
Goes tgo aac