nothing yet Aaron.
Planning on pulling it into the workshop in the next couple of weeks though, then I will make progress
Dan
nothing yet Aaron.
Planning on pulling it into the workshop in the next couple of weeks though, then I will make progress
Dan
Really looking forward to this one
Nope, he's been too busy, I think we should ban him for a while so he can get on with it
Ah fair play dan, good luck with it.
What are you planning to increase the HP!?
Wind up the boost and diesel drfit ftw!
Just to bump this Dan..... Did you finish it, or has this too fallen by the wayside
hahahahahaha
Well with the help of Rads S13 and Paul_S13 I am pleased to announce
it's ALIVE
Tonight I will pulling it into the unit and carry out the following jobs over the week:-
Remove over 100 excess wires from the loom
Make an exhaust system
Fitting a Vectra Clutch Master Cylinder
Modifying the actuator so the bonnet shuts
Fitting a S14 Rad
Mounting a P38 Range Rover intercooler (Larger than the original and full alloy)
Making a propshaft
Fit all the interior back in
Drive it out
Yes!
-mobile phone post-
How does the gear stick sit in the original hole in the transmission tunnel?
Are you using Nissan or BMW clocks in the dash?
Did you have to modify the bulkhead or transmission tunnel with a tool of persuasion (hammer)?
Any word on the 200DX? :P
was finished ages ago lol. i think mr ghazoobie has it now
Ghazoobe has it and it's up for sale
See link in my sig for how it is currently
Its sort of finished, still needs some bits finishing off properly. Have been slowly getting through it all.
Aye, link in my sig shows/describes how it is currently (although it is also currently being prepped to be painted).
bovvered?