Useful 180sx/Ps13 Information

[norfy]

Service Parts.

non vvt rocker cover gasket - Nissan - 13270-52F00 Just over £12
rocker cover plug hole gasket (this is the vvt one which is better) - Nissan - 13271-65F00 £8
Oil filter - Nissan - 15208-70j00. Also same as '96 micra (k11) Halfords part number HOF339 (about £9)
Alternator belt - Nissan - 11720-52f. Micro-V part No. 5PK933
Power steering belt - Nissan - a172m-59ssa-vw
Spark Plugs - BKR7EIX - NGK Iridium - On standard car with Aftermarket Air filter and exhaust
Engine Oil Grade - Carta has used Silkolene Pro S 10-50 and 10-40 - Any other recommendations?
Gearbox Oil Grade -Carta has used Silkolene SILKTRAN SYN 5 75W-90 Fully Synthetic Gear Oil
Differential Oil Grade -Carta has used Silkolene BOA 90LS in his Nismo 2 Way - What do people use in standard differentials?
Battery - 054
Oil Filter - http://www.opieoils.co.uk/p-6789-oil...r-2326600.aspx

Redtop Oil Strainer Upgrade
Upgrade for Redtop oil strainer 15050-65f01 its the oil strainer from the Blacktop non vvt, has a wider mouth than the Redtop strainer. note, this is a s14 vvt stock part.

Engine Block Codes
Redtop is 50f
Blacktop Non VVT is 52f


Service Manual

This is very limited and the only one available is in japanese showing only the engine mechanical section and a quick eccs overview

http://180sx.strent.net/servicemanuals.php


180sx/ps13 Sr20det REDTOP ECU Pinout (kouki/type-x has a different pinout but the same connector)

http://browsebug.info/wp-content/upl...ecu-pinout.jpg

180sx redtop and blacktop straight cam (kouki) pinouts side by side. It is possible to swap some pins round on a kouki engine loom to use a chuki (redtop) ecu and these pinouts will help with that. If you're wanting to do this then you'll also need to earth out the Brown/Yellow wire from the Lambda sensor as the redtop is earthed but the kouki has an earth control from the ecu.

http://wheretobe.co/wp-content/uploa...ecu-pinout.jpg



Fusebox layout

http://180sx.strent.net/documents/fuseS13.gif

Airflow meter upgrades (mainly Z32)

http://www.sr20tuning.com/z32afm.html

Fitting a rear foglight to a 180SX (required for MOT):

http://www.sxoc.com/vbb/showthread.php?t=261340

Kouki bulb holders. The original harnesses are available from japan but are roughly £50 each. A cheaper alternative is to buy x4 7440 bulb holders from Ebay (about £10), and x2 7443 bulb holders from Ebay (about £6) plus bulbs and wire them into your car.


Using a vvt block on a non-vvt sr20

http://www.sxoc.com/vbb/showthread.p...88#post6517188

[Carta]

Have tided the thread up, any more information let me know.

[Sidewaysfun]

T25g oil feed thread is the same size as a T25. (probably obvious but hey)

7/16 UNF with 24 tpi

Handy to know if ordering a new banjo bolt when upgrading to braided lines.

[doz_sr20]

Red Top SR20 Cam Cover Gasket:

Part Number: 13270-52F00 (outter part)
Part Number: 13271-65F00 (inner part around the plug holes)

[Micraplay]

s13 SR20 oil filter thread is same as CA18 - found this out when i bought an s14 relocation kit, needless to say it didnt fit!!

[redsx94!]

s13 SR20 oil filter thread is same as CA18 - found this out when i bought an s14 relocation kit, needless to say it didnt fit!!

Also the same as a pulsar

[John Bennett]

Service Manual

This is very limited and the only one available is in japanese showing only the engine mechanical section and a quick eccs overview

http://180sx.strent.net/servicemanuals.php

Heh, I scanned that. Forget it now though, the whole lot is here:
http://www.sxoc.com/vbb/showthread.p...ls-to-download

The latest Brother £200 A3 ADF scanner is a wonderful thing

[Joesefer]

anyone any idea on fuel filter?

[Sidewaysfun]

anyone any idea on fuel filter?

I used a 300zx one mate. They are a bit bigger than stock ones. I'm guessing that an S14 one would be the same as stock.

[doz_sr20]

Just found all this out the hard way:

Stock rear brakes comprise of: P10 eGT Primera discs, S14 rear pads.

To add to peoples posts above, oil filter also the same as P10 eGT Primera.

Sent from my HTC One_M8 using Tapatalk