i keep seeing s15's with gauges where the 3 middle heater pods are
is there a adapter, part id need to buy to do it ?
or is it a cut and shut jobbie?
what size guage is needed?
i keep seeing s15's with gauges where the 3 middle heater pods are
is there a adapter, part id need to buy to do it ?
or is it a cut and shut jobbie?
what size guage is needed?
Its a 60mm gauge you need pal, and you can't get any parts for them, as far as I know, you just take the vent apart and do the best you can.
think the 60mm just fit straight in as theye were going to stick gauges there in the first place but were too cheap to finish it so whacked vents instead
How to remove S15 air vents. You'll need to login.
S15 Useful Threads
S15 Useful Threads
S15 Useful Threads
S15 Useful Threads
yeah 60mm gauges just push in im in middle of doing it at the moment
what about changing the stock boost gauge?
Just done that now dude, take the front off the pillar pod and either chisel or dremal back the inside of the pod holder until it will take a 60mm gauge ( that's if you wan a 60mm gauge in) they fit pretty easily.
under the bonnet where the boost solonoid is by the drivers side strut brace, under neath the solonoid is a boost pipe, plumb it in there
regarding the gauges in the vents, take the heater vernt out (clip at the top and bottom, use a small flat head screwdriver)
once out don;t break or cut anything incase you want to put it back together at some point. Undo the screw at the back of the heater and take the flaps off, and unclip the mesh plastic back with the 2 clips on the side so that your left with the centre section of plastic. 60 mm gauge fits perfectly in (thanks nissan )