hi there,
i am buying some hub centrics and have been told the centre bore 73mm, is that correct.
any help is good help.......
thanks guys
hi there,
i am buying some hub centrics and have been told the centre bore 73mm, is that correct.
any help is good help.......
thanks guys
Wheels or hubs? Hubs are 66.1mm, a lot of aftermarket wheels are 73mm.
arrrr, well these hub centrics are 73mm bore. so i guess they will fit over my hub and my wheel will fit on to the "hub centric"
A 73mm bore won't fit a 66.1mm spigot.
The hub centric needs a 66.1mm bore and 73mm spigot.
Yep your right I was sitting here with pair of bolt-ons and didn't think about the size of the hub
tbh i find they center them selves if nuts are done up gradually evenly/cross pattern and not had problems with balancing/vibrations,
I know your now reading that with a look of complete disgust as its not the done thing
Without the spigot it will go on fine, but the problem is wheel studs aren't there to take the weight of the car, that's why they have hubs that match the centre bore of the wheels. The studs are just the to hold the wheel onto the hub, while the hub takes the weight. I've known people run without spigots and it be fine, but I've also known people to have studs shear because of it...
took it all in guys...... nice one. well after measuring them it turns out the rear measurement of the hub centric ( spacer ) is 66.1 ish..... And the spigot is 73mm ish maybe a tad bit less. And I do mean a bit. but they all fit perfect, proper snug as.....
Thanks guys for all the information