not just an engine thread but a total car rebuild thread starting with some shiny bits
not just an engine thread but a total car rebuild thread starting with some shiny bits
Looking good mate!
the intake manifold and de-jetro will be put on my standard engine first while i sort out the rebuild, got loads to do, finnish the body kit, welding the rollgage suport plates, then theres the adjustable rear camber/caster arms, where do i start
so there is no budget then
What are you going to be using the car for?
funOriginally Posted by polo
so there is no budget then
What are you going to be using the car for?
Lookin good mate
Why 2 sets of arp bolts?
1 head set and 1 mains setLookin good mate
Why 2 sets of arp bolts?
decided to have a go fitting my new plenum
as you can see the boss for the temp sensors is to close to the thermostat housing and will need to be plugged and i will fit the sensors into 'WATER TEMP SENDER PORT SLEEVE' from GAUGEPLACE
modding the fuse box to give me more room
i have cut it flat and will mount it closer to the wing on a flat plate, had to do this as it fouled the throttle
what make is that manny? can you use the origanal injectors, fuel rail, ICV etc, etc with it
the ivc needs a simple mod, the fuel rail needs cutting so the fuel feeds from the left hand sidewhat make is that manny? can you use the origanal injectors, fuel rail, ICV etc, etc with it
if your good with your hands YOU CAN DO IT
Looks good but where did you get that intake manifold ?
http://search.ebay.co.uk/_W0QQfgtpZ1...Q5fperformance
very nice indeed. That manifold looks well made, what are your thoughts after fitting?
its not all done yet, i need to make a new cold pipe, and a few other things, it does seem well made the only big problem is the temp sensors fowling the thermostat housing
nice stuff dude, ill be watching this thread with interest - good luck
Its gone!
trying to find some where to get some boost nipples so i can connect my sensors to the plenumnice stuff dude, ill be watching this thread with interest - good luck
That manifold looks like it takes top feed injectors rather than side feed.
i was going to say the same
takes the standard fuel raili was going to say the same
well had to mod the fuel rail but it fits and made a suport that also holds my avcr, d-jetro and water injection sensors
Posting Permissions
Reply With Quote
