how do you go about it? that flimsy plastic bit at the front wont hold a stereo in solid for sure
i think i still have the old one but i didnt remove it so im not sure on how to go about securing the new one in?
how do you go about it? that flimsy plastic bit at the front wont hold a stereo in solid for sure
i think i still have the old one but i didnt remove it so im not sure on how to go about securing the new one in?
Dunno about the fitting but fcuk me you will have fun with the wiring
Originally Posted by scimmy benOriginally Posted by sprout
im a electrician
the wiring is complete already, i can figure out how to fit it but im not in the car atm so thought id ask so i could be pointed in the general direction.
yes all them lovly pinks and erm pinks
flimsy plastic bit??? that's just the cover. there's a big load of metal framework behind that!!
yup, how do i attach the stereo to it?
remove the big plastic trim (the one that goes round ash tray as well) then undo 4 screws. one in each corner. these tend to be stupidly tight for some reason.then the whole framework will come out, it's a big lump. careful not to scratch the trim in front of the gear stick when you slide it out, its quite tight. then youll see how the stereo holds in
old one has already been removed. when i got it it was a bunch of wires
how does the new one hold in?
Mine is wedged in with a pack of RizlasOriginally Posted by Adam-D
Good luck
Originally Posted by scimmy benOriginally Posted by sprout
mines kinda wedged in , but with folded cardboard instead !
i want something more subtansial "sp"
ie bolted down
hahahahahahahahahahaha mine and pukkasilvias are wedged in with duck tape and an old porn mag. lol
im make'ing up a bolt in metal bracket system
yup its in
the black surroud bit doesnt sit fully flush but at least its bolted down to something solid