Search:

Type: Posts; User: stevie t

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Thread: vacuum pipes

    by stevie t
    Replies
    2
    Views
    95

    ok dont suppose you have any pictures, there are...

    ok dont suppose you have any pictures, there are 8 points in total for on the plenum and 4 on the throttle body,
  2. Thread: vacuum pipes

    by stevie t
    Replies
    2
    Views
    95

    vacuum pipes

    im doing a sr20det, bent cam engine and im not sure what pipes go where on the induction, its going into a project im doing, i want to run a boost gauge and have a avcr boost controller, can anyone...
  3. Replies
    4
    Views
    112

    yes i might have been better of paying a little...

    yes i might have been better of paying a little xtra
  4. Replies
    4
    Views
    112

    tbh that would make sense, i was just a bit...

    tbh that would make sense, i was just a bit surprised that there was so few gaskets, iv done pinto,s and mainly chevy engines which normally have more gasket than you need
  5. Replies
    4
    Views
    112

    engine gasket sets

    hi, iv bought a full engine gasket set of ebay and im not sure its a full set, there's no timing gear gasket no sump,thermostat housing, water pump, no o rings for injectors and that just what iv...
  6. Thread: sr20det swop

    by stevie t
    Replies
    0
    Views
    72

    sr20det swop

    hi everyone, im about to strip my s14, im putting the engine and box into another car, i want to use the ecu etc any advice on what i need and dont need in general, iv read a few bits here and there...
Results 1 to 6 of 47
Page 1 of 2 1 2