Well it looks good from about 30ft! Bit tatty up close. But yeah, it's a handsome shape and only getting better with age.
I do fancy a ducktail spoiler, for the looks alone...
Type: Posts; User: daveyboydave
Well it looks good from about 30ft! Bit tatty up close. But yeah, it's a handsome shape and only getting better with age.
I do fancy a ducktail spoiler, for the looks alone...
Holy shit, I am terrible - for some reason I don't get emailed when this gets replies any more, sorry I missed this.
Work has meant I'm away a lot again so slow progress and minimal usage one...
Yes, will of course secure properly to the strut.
Have seen some of those conversion kits but none of the descriptions say whether they go all the way to the caliper, although some specifically...
Should point out, I have R33 GTR brakes so i don't know if that makes a difference (or is the reason for the hard line bit) - previous owner did the conversion.
I have noticed that that it's...
Oh wise ones of the forum...
Just took off my front calipers of the get them refurbed, and on one side the little length of hard line that goes from the connector block on the strut to the caliper...
Haha, yep.
I went ahead and ordered them. Like you say, worst case they warp or wear and I change the discs sooner than otherwise, it's not like they've set me back big bucks. Will take a couple...
Yeah, likewise I'm know GKTech has a good reputation, so I don't imagine they would promote crap components (although I came across some disparaging remarks about GKTech-stocked HFM brake master...
Thanks for the pad recommends, will check them out.
Come across a 2-piece disc from GKTech that seems a steal at £360 (other 2-piece discs all seem to be triple that price). But I can't find a...
Front calipers need a refurb and thinking about replacing the discs and pads at the same time. I have the Brembos off a R33 GTR.
Ferrodo DS2500s have served me well in the past, but what's the...
Dammit, no millions for me:
https://bluewireautomotive.com/products/magnet-speed-coil
This one is in oz but I only spent 1 min googling, I'm sure you'll find something better.
Sent from my...
I'd be amazed if there isn't some solution where you could mount magnets to the prop shaft, and a proximity sensor, which can be calibrated to produce a speedo signal. Almost certainly something off...
I've used a CTEK battery conditioner for years across several different cars now, and i always see them being recommended on owners club forums etc. Can't fault it.
Sent from my SM-G960F using...
I've used Conceptua a few times, for gaskets and Nissan oil filters typically. Have found them to be good, and the parts certainly look genuine (but I guess it's impossible to be 100% sure).
I had to use Nengun for an Apexi air filter, couldn't find anywhere UK based when I looked a year or two ago.
Spark plugs are easy to get, I tend to use Opie Oils.
Yes, mine was a dodgy battery too! I can probably find the link to the eBay replacement i used if it's helpful.
Sent from my SM-G960F using Tapatalk
Difficult to compare without knowing your oil grade and temps, since this is all about viscosity.
Mine regularly fluctuates below 1 at idle after a session on track, with oil temp typically around...
I appreciate the encouragement! I think I'd wait until my box fails before going down such a big job (for me at least).
Sent from my SM-G960F using Tapatalk
I refurbished a used BM57 after my original BM57 didn't allow shimming of the internal proportioning valve.
Problem is, on re-assembling and bench bleeding, I'm getting a dribble of fluid out of...
I'm by no means an expert, but there's a lot that can influence brakes. Just changing the calipers doesn't automatically guarantee a certain effect. For starters, are they bled correctly? Are the...
I have a koyo rad and managed to get the stock fan and shrowd on, so I'm not quite sure why it won't fit on yours. Can take pictures if it would help.
Sent from my SM-G960F using Tapatalk
For future reference, should someone be searching for the same issue, I can confirm:
The two Nissan BMC OEMs, Nabco and Tokico, whilst externally similar and interchangeable, use different...
Morning all, another battling with brake balance thread...
I have a Nabco branded BM57 installed by one of the previous owners - I'm not sure if it's R33 GTR, or 300ZX, or whether it makes any...
Did you get anywhere with this? My BM57 seems to be the same, and similarly can't find any info online about whether the internal prop valve can be shimmed or otherwise overriden.
Yes, the closer ratios would be a bonus, for my track car anyway, especially since it looks like 1-3 are shorter but 5th is actually longer geared. So faster acceleration in the gears most used on...
Does anyone know how difficult a job it would be to fit an OS Gilken gear set? Does it need crazy specialist tools and a PHD in gearboxes?
Given that finding decent SR gearboxes is getting more...