Search:

Same as immy, ive ziptied it on.

i have just left them open like that, never had any issues.

Just turn it into 1, will make no difference.

350z discs are 324mm if you cant find any. They may work and be more readily available.

I run -3 deg both front and rear, but its a track car, and it handles quite well. Very neutral. But it depends on how much youve lowered it; ive lowered it quite a bit (maybe 40-50mm) and i run...

ive got an ebay special and worked for about 2 years and then i kind of stopped putting water in because i never used it, and i dont think it works anymore now. But for the price you cant go wrong.

No, nonABS models come without this ring and sensor.

This is literally what I have just done. I have fitted a 2871r with 740cc injectors and was able to start the engine and run, but its stupidly rich and you cant drive it, but it will run. I will now...

If you look on the upright it goes to the ABS tone ring, its a wheel speed sensor.

What ECU wiring would cause both injectors and spark not to work? only the CAS or is there anything else?
Just so i know, the standard kouki ECU works fine, its only the zenki ECU plug which i have...

ok, thanks for that. Ill check the CAS wiring then. Looking at the diagram it says that the 4 ecu pins go into 2 on the CAS so hopefully should be right. Is there a good way to check the wiring? like...

it always goes crazy, even on the original ECU. Maybe a little more erratic! Would does this mean?

Anyone?

All, I've recently rewired my ECU plug to accept a zenki ECU as I have a PowerFC D-Jetro and can't get the car to start. It turns over and the fuel pump primes. I have checked the wiring as best as...

I'm currently building my engine so can't really recommend anything yet until i run it, but I've got Wossner pistons and Apex performance rods, ACL race bearings as i've heard good things about them,...

I can't see how a clutch would affect whether a gear stays in or not, and neither the mounting of it. Its hard to incorrectly mount the gearbox to the engine unless they missed the metal "seal". The...

Thats a pretty good idea. I've always used a plastic bottle and the thing never stays up when the tube is trying to move it around so you have to hold it while actuating the nipple.

I've just joined the two pipes and then let the other vent to air and I dont have any fuel smell even when left in a closed garage.

Thank you for the feedback.

Can anyone confirm if this is correct?

Is it ok to mount the cover after the head? I'd be worried the headgasket has been pinched on the end of the block without the support of the cover. Was there a reason why you assembled this after?

No one?

As described, I bled all the lifter when they were out of the engine and went rock solid. Then installed them and ensured there was oil in the hole and also placed oil under the rocker but,
when i...

Ah ok, vicino. Forse ci conosciamo gia :D
Fai drift o pista? Io mi sto preparendo per la seconda stagione del TAI.

Is the tensioner loose? (can you move it left and right)
I doubt a thicker head gasket would have an affect as it would need to be huge!

I would check the path of the chain and ensure its not...

Youre right, the swing may not be enough. I might just move the wiper to the middle and see how much it swings.