It' got to go sadly :(
http://www.sxoc.com/vbb/showthread.php?p=3211043#post3211043
Type: Posts; User: alextann81
It' got to go sadly :(
http://www.sxoc.com/vbb/showthread.php?p=3211043#post3211043
:confused:
You have missed the point here. All I said was that a leak in the exhaust pre lambda is likely to affect its operation. I did not say this WAS the fault with your car. I certainly...
:nod: will do :D
So do you think that 250 bhp is realistic with this intercooler, ND stage one chip, 2.5" turbo back mongoose, K&N and boost set about 14-15 psi?
Oh also already have walbro...
Thats what I wanted to hear!
I didn't think it would be too bad too fit as the width is about right and I've got the two pieces of angle pipe attached to it which can be shortened as nessisary...
Just found this in the back of my garage :
http://s154.photobucket.com/albums/s255/alextann81/
I've put it next to the car to give an idea of the size. It's not big but it would fit very...
In the intrest of safety take it to a garage and have them check it! It should cost very little and you won't be risking you life and getting a sleeve full of stinking gearoil! :wack:
Very unlikley mate :(
Would be worth investing on a "magnet on a stick" tool if you don't have one. Have a fish around and you might get lucky and pick it up. If the engine isn't in the car then you could turn it upside...
Could be something at the rear end causing you this problem. Get that checked too.
I concur, on any car if the exhaust is leaking before the lambda it affects the operation of the lambda. Can't say why for sure, it just does! :D
Recently had the same problem with a similar vehicle (1997 214), turned out to be a faulty ECU (the MAP sensor is in there and that was the problem). Was cured with a used unit from a scrappy.
Well done, glad you got it sorted. :thumbs:
Went there a few years ago, great nightlife! Enjoy!
Small right angle air drill is probably the best tool (but you do need a compressor). Start with a pilot hole of about 4mm. It is vital that you get the hole bang in the middle of the stud - and...
Sounds to me like you don't have enough fuel pressure. I think in your other thread you said the car had been fitted with a new pump but that wont help if for example the power supply to the pump...
The thing is that it isn't just overfueling that can give you poor MPG. If the fuel going in isn't being burnt properly that will affect your MPG even if it is the right amount of fuel being...
Try and change a bonnet release cable on a laguna, now that bolt under the dash is the worst :mad: :D
No that soundn't make any difference if the stat is working properly.
Grow, damn you, grow! :)
I watched that DVD earlier today oddly and the rouse is cool :thumbs:
WTF happened to the petrol growing though??
Simpsons everytime. I even named my cat Simpson after the show :D
Yes I do, I am based at haytor (just up onto dartmoor from Bovey Tracey) happy to help with anything 200sx related. S13 courtesy car available too :D Work number is 01364 661555 - Tor Garage...
LMAO, surly whoever built that doesn't expect it to work!
Hmmm so it does, LOL :D
That's is amazing, how can they make new ones for £40? :eek: Cheap ones are always smaller tho...