Looking for s14a rear quarter panel preferably rear drivers side quarter as I need to weld a new panel in, I’m in Bristol know anywhere I can find something like this?
Type: Posts; User: notty
Looking for s14a rear quarter panel preferably rear drivers side quarter as I need to weld a new panel in, I’m in Bristol know anywhere I can find something like this?
Hello I’m curious to see does the gtst r33 subframe fit directly into an s14?
Reason I’m asking is I want to replace my rear subframe and all the bushings as my current one has seen better days...
Okay guys thanks for the replies and input
hey guys recently had an MOT and failed on a few things with a bit of welding work to be done underneath.
the one im worried the most about is this:
Anti-roll bar linkage attatchment...
Anyone have any idea?
Okay for example I’ll be at a drive thru and put it in neutral and pull the clutch back out and sit there and it will idle really roughly, I have to give it
A little rev to gain back to normal idle...
Hey I have a 1999 s14a and sometimes when I push the clutch down on the way down the RPMs drop and causes it to idle really badly and stops when I put it all the way to the ground, tires out my foot,...
It’s mad how it could really be something this simple and easy to fix, I keep overlooking the basic and first things I just check and cancel out...
Hi when I drive my car in traffic I have to keep high revs because it always feels like it wants to stall, I have an organic clutch and a lightened flywheel but even before these were installed it...
Okay guys thanks for the information and help I will have a go at pulling the turbo out with the Down pipe attached, thinking about getting an aftermarket downpipe anyway, it’s just I thought it...
Hello people trying to replace my turbo and I’ve got everything lose except the down pipe from the elbow, now as far as I’m aware there are two bolts I’ve taken off from the top of the engine and one...
Okay dude thank you!
What’s the size of the studs on the exhaust manifold that bolts to the turbo?
Hi people I’ve got a small hole in my decat pipe which is a two piece pipe held together by a U clip, could this affect my performance by much?
Okay Ive checked the Piping for boost leaks and I havent found anything that has caught my eye or even looks loose, everything is on quite tight, however I did remove the heatshield on the exhaust...
Okay I have read what you have said and I’ve checked the coils which seem to be in decent condition, however I checked the spark plugs and one out of the four seemed to be discoloured from the rest...
Hello Ive recently noticed a significant drop in power on my s14a 1999, sr20det. this started a couple of months ago and now its progressively gotten worse.
Sometimes the turbo will spool without...
Okay mate thanks for the input I appreciate it I will give this a try!
How would I check the coil packs for faults?
Hello people I’ve recently replaced my clutch and flywheel plus the bolts and I’ve noticed that the turbo lags horrendously, I know it’s a laggy turbo anyway but it was nowhere near this bad when I...
Hey so I’ve literally just rebuilt my drivers side rear caliper with a new piston, square seal and dust boot, funnily enough when I came to do this the piston never had a dust boot on it! Is this...
Okay just ordered the driftworks arms.... how much on an average do you think it will cost for a garage to fit both arms?
Ball joint is worn quite badly on my nearside lower front control arm, now I am going to replace them both with Driftworks adjustable arms, will these just simply fit into place without anything else...
I have no power to the pump, it worked before and there seems to be a pair of cables that go to a float switch?
Am I missing something is there a fuse somewhere?
Does the wiring to the washer...
I was in the process of changing discs and pads and then the pipe coming from the caliper has snapped off!
This was old and corroded
Can I just replace this with another brake line, is it even...