Search:

Awesome news!!! Top end sound any better?

My friend had his fruity Almera mapped by Hudson, would quite like him to map mine.

I find indicator arms in that orientation a pain at the best of times perhaps try to cross them more like in the FSM?

https://i.imgur.com/8kBRqZv.jpg

The errors could be in the arms itself but...

U5014

Opie was the cheapest I could find when I got mine. https://www.opieoils.co.uk/p-80815-ngk-ignition-coil-u5014-ngk48041-plug-top-coil.aspx

They give you 10% off too with the code: SXOC

They are more sensitive, which is maybe why they say this. It also mentions calibration intervals in the manual but I know this is usually forgotten about, I did myself until I had issues.


Page...

Mines in the downpipe before is goes under the car. From what I remember the manual says 12-18" from Turbo at 12-3 o'clock position. I made the right length stainless boss so it didn't stick in too...

I had a similar issue with my Innovate LC-2, seemed to be slightly laggy. I emailed Innovate and they said to recalibrate the sensor, once that was done everything has been fine.

http://www.ogaracoach.com/vehicle-details/used-1988-lamborghini-countach-2dr-coupe-beverly-hills-ca-id-14811503
...

Had a search but can't find what I'm after...

Does anyone have any shock length measurements for fitting their CS2's or pictures?

Just trying to get in the ballpark to set the ride height. :D

I ran with the standard bolts but was going to change them for some 10.9 BZP cap heads.

http://i106.photobucket.com/albums/m272/drqrty/59CA9DAD-7F82-4B72-841F-5756A80FE872_zpsko1jmtbs.jpg
...

I apologise, I thought if I put "next to some Birds" people might think I was looking for Max Power chavs sprawled across the bonnet.

Fair play if we see them next to some Ambrosia.

This is amazing!!!!! :thumbs:

Can't believe how many new Nissan and Aftermarket parts you've sourced.

Clear indicators tinted or are they smoked ones?

+1 for RHDJapan.

Wouldn't have thought it would be too hard to make something though?

Got a part number?

Bit of an update - Cleaned the MC and used a C clamp to hold the slave piston in. I used a syringe to push fluid through the bleed nipple on the MC to the slave first, once almost clear I then bleed...

Yeh, I couldn't find any online thought I might try Nissan.

When I try and bleed I don't get any fluid dropping which is why I thought cylinder originally but when I pump the line full of fluid...

Might try a rebuild kit for the master cylinder, if they are available?

Ok so after reading all the threads I could find there seems to be a few people struggling but not quite the same issue.

Basically I have removed the valve in the clutch line and swapped it for a...

Cheers chaps.

Ok, so this sounds like a silly question as there doesn't seem a logical reason why they physically wouldn't fit.

But could someone please confirm this before I part with cash.

:thumbs: