Search:

Type: Posts; User: dannyboi200sx

Page 1 of 20 1 2 3 4

Search: Search took 0.13 seconds.

  1. Replies
    1
    Views
    1,612

    Roof rack

    I have a s14/a roof rack I’m willing to sell, but I’m unsure on how or what price it should be anyone help??


    Sent from my iPhone using Tapatalk
  2. Replies
    8
    Views
    533

    Buy a 33 super low down pipe from japspeed, and a...

    Buy a 33 super low down pipe from japspeed, and a r33 elbow will fit in the standard position, you won’t need to tune the engine with the inlet manifold but it’s a pain to change while the engine is...
  3. Replies
    8
    Views
    533

    Use a rad from either a s13 or a ka24, they fit...

    Use a rad from either a s13 or a ka24, they fit no problems.
    I’d personally go link as it’s a better Ecuador to go for and you shouldn’t have to worry about arb or sump.
    Cooling isn’t an issue if...
  4. Replies
    13
    Views
    4,070

    I cant fully remember but i'll have a look at my...

    I cant fully remember but i'll have a look at my loom
  5. Replies
    13
    Views
    4,070

    I haven't got the hot start on my RB and never...

    I haven't got the hot start on my RB and never had any problems with it starting
  6. Replies
    13
    Views
    4,070

    just delete the hot start

    just delete the hot start
  7. Replies
    13
    Views
    3,574

    Best way to find out is to take a tape measure...

    Best way to find out is to take a tape measure from the centre on the spacer to the lip of the arch and then measure the centre of the wheel to the outside of he wheel and see if the wheel width is...
  8. Replies
    13
    Views
    3,574

    You need to fit a 15mm spacer on the front as a...

    You need to fit a 15mm spacer on the front as a minimum, then they will clear the brakes, but don’t forget then they will be a -5 et.

    You may have to add a bit of camber to make them properly fit...
  9. Replies
    187
    Views
    35,735

    So a small update on this Recently attended...

    So a small update on this

    Recently attended retro drift challenge/forces drift series on Sunday just gone

    Track was awesome and very fast, if I can recall it was 70-80 mph entries and to be...
  10. Replies
    8
    Views
    446

    I used them and there still coming loose, I'd...

    I used them and there still coming loose, I'd personally ring up Nissan as they still stock them

    Sent from my E6633 using Tapatalk
  11. Replies
    8
    Views
    446

    I used genuine the first time, kept the same...

    I used genuine the first time, kept the same bolts and just changed the nuts

    Sent from my E6633 using Tapatalk
  12. Replies
    8
    Views
    446

    Yeah I haven't thought of that to be honest,...

    Yeah I haven't thought of that to be honest, thanks

    Sent from my E6633 using Tapatalk
  13. Replies
    8
    Views
    446

    Prop shaft annoyance

    Hi guys, I've noticed that every time I check my car underneath I have to tighten my prop shaft bolts.

    I have done this a few times, at first I thought it could be the fact the bolts and nuts were...
  14. Replies
    4
    Views
    312

    When I took them apart the whole shim was...

    When I took them apart the whole shim was touching the piston, I did clean them all up and check if moving correctly and they do its just a strange one ad I've never seen it before.

    They were...
  15. Replies
    4
    Views
    312

    R33 rear brakes

    Quick question guys

    I have this set up on my car and changed the pads today and noticed that they wore more on the top edge than the rest, anyone shed any light as to why??

    Sent from my E6633...
  16. Replies
    13
    Views
    671

    Checked your water pump? Sent from my E6633...

    Checked your water pump?

    Sent from my E6633 using Tapatalk
  17. Replies
    11
    Views
    2,537

    Hello Alex 👋 Sent from my E6633 using...

    Hello Alex 👋



    Sent from my E6633 using Tapatalk
  18. Replies
    5
    Views
    378

    Oil cooler will help, not only reduces oil temps...

    Oil cooler will help, not only reduces oil temps bit also coolant

    Sent from my E6633 using Tapatalk
  19. Replies
    31
    Views
    1,805

    I'd personally go to 10/50 if your going to use...

    I'd personally go to 10/50 if your going to use it for track, and place the oil cooler in a better position, but not in front of the Intercooler.

    Sent from my E6633 using Tapatalk
  20. Replies
    143
    Views
    11,589

    Yeah I remember Sent from my E6633 using...

    Yeah I remember

    Sent from my E6633 using Tapatalk
  21. Replies
    143
    Views
    11,589

    Well... Does it matter if you wash a car at a...

    Well... Does it matter if you wash a car at a show??

    No!!

    I last bought my car out to a show last year, washed it with a petrol station brush and that was it, I turned up to the stand and...
  22. They look soooooo cool Sent from my E6633...

    They look soooooo cool

    Sent from my E6633 using Tapatalk
  23. I have mine where the passenger airbag used to be...

    I have mine where the passenger airbag used to be and yeah it's about 30 wires give or take, I labelled all mine up before moving

    Sent from my E6633 using Tapatalk
  24. id recommend moving the fuse box, personally id...

    id recommend moving the fuse box, personally id put it where the passenger air bag is/was... that's if you've removed it.
  25. Replies
    38
    Views
    4,942

    I'm game for this Sent from my E6633 using...

    I'm game for this

    Sent from my E6633 using Tapatalk
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4