It runs!!!
Not sure what it was, combination of old fuel extremely low,
Change fuel filter, plugs, fresh fuel
Think the culpret was the ecu plug though just gave it a wiggle, had it before...
Type: Posts; User: cuttsy224
It runs!!!
Not sure what it was, combination of old fuel extremely low,
Change fuel filter, plugs, fresh fuel
Think the culpret was the ecu plug though just gave it a wiggle, had it before...
hi guys - started my ca18det for the first time today in two months (always started first crank ran smooth)
started but runs extremely lumpy then cuts out after 10 seconds or so - doesn't rev at...
http://uploads.tapatalk-cdn.com/20160203/0c2904355d43ac1d45bfebe1bab51e81.jpghttp://uploads.tapatalk-cdn.com/20160203/213025572cb624a8f950fb21d7f37224.jpghttp://uploads.tapatalk-cdn.com/20160203/168aa...
sky wouldnt insure me at 21 but i had a claim last yr, anyone else i should try?
I have a black s13 in Sheffield and my mate has a sky blue s14
Sent from my iPhone using Tapatalk
Who's car was this from castle Combe on the members stand ??
As I wanted to see what turbo and engine specs were I was going to buy this as donor for mine
If I remember correctly it was for...
I'm 21 I can't get quotes as good as that
Sent from my iPhone using Tapatalk
I pretty much did everything bar suspension struts gearbox, prop and exhaust.. Take wheels off and get in them arches and blast in all the book and crannies.. I seem to think you have to run it at...
http://uploads.tapatalk-cdn.com/20160128/b137ca13fb2165dbba8b12f826cbe67f.jpg
Sent from my iPhone using Tapatalk
Get a 2hp 25l compressor off gumtree for £40
Underseal guns are about £7
Cans of underseal are around 7 each I used 3 but I put loads and loads on
Wire brush the loose off and make sure the...
I read somewhere that it needs a different oil pump for turboing, and that the engines valves and compression ratio isn't suited for turbo and super charging
Sent from my iPhone using Tapatalk
Thanks they would be better than the mank orange ones! Apparently euro car parts has standard ones but we'll see
Bit crappy that it's so hard to get normal ones
Sent from my iPhone using...
Apexi don't have any and drift works are 50£ as they only sell full set [emoji21] and there orange.. Already got goodridge up front
Thanks anyway
Sent from my iPhone using Tapatalk
Where to get rear flexi brake hoses for s13??
They are on back order from Nissan Europe at 12 days mot retest runs out on 28th and mines failed on both
Sent from my iPhone using Tapatalk
my mate got a bosche one from costco and adapters for the terminals from a motor factors, that's been fine
did this throw a code or not?
I have videos of my engine knocking on two different engines
the first was mains and rods
the second is suspect big end if this is any use, gets worse when its warmer and at higher revs
Get your head pressure tested.. I did rings and crank bearings.. Only to discover low compression was due to valves leaking
Sent from my iPhone using Tapatalk
Thanks not worth a shot then
Sent from my iPhone using Tapatalk
Will a s14 exhaust fit an s13 ? From the cat back
Sent from my iPhone using Tapatalk
Reg is 1993 but it could be a crossover if it was registered late - the ecu is numbered 76
But then again it may not even be the original engine..
Sent from my iPhone using Tapatalk
Just a price I've seen on here from someone's previous work they've had done, the place I use charged me 90 for a .50 crank grind on all journals and 30 for honing + wash so they may be reasonable
...
Was worth a shot before I start throwing money at it [emoji849]
I reckon it's valves, I found the compression test results before I did rings 130-135 psi when warm
I was getting around 120ish...
Ordered a leak down tester, won't start without easy start, just going to retorque the head
Sent from my iPhone using Tapatalk
My ca18 struggles to start in the cold, and takes 30 seconds before it runs smoothly after warming up
changed the cold start valve for a spare i found in my box. (have ordered another as this...