I have a sr20det in my kitcar. I've replaced my AFM cleaned my ICV and done a compression test and it's all good.
When I go to start the car it struggles to start. It takes upto 15 to 20 seconds...
Type: Posts; User: mk85
I have a sr20det in my kitcar. I've replaced my AFM cleaned my ICV and done a compression test and it's all good.
When I go to start the car it struggles to start. It takes upto 15 to 20 seconds...
I purchased a avcr of ebay and when it turned up all the plugs had been cut of the loom so i have no idea what goes where.
I have managed to wire it up to the ecu and have the read outs working...
When i bought the car it was one of those needs 500pound to finish and afew hours. But it was an absolute mess and decided there and then withing afew minutes to just strip it and sell what was good...
Thanks dan. I know pretty much most kit cars have that issue but its on my long long list.
Any idea how to start a build topic?
Am here to share my kitcar build and look for info on here as i go along with my sr20 engine install and build
The day it turned up
...
Am running a sr20 in my kitcar. The sci and loom has been striped to a bare minimum. The fuel tank unfortunately sits inches behind me and I plan to run this on its own power supply. I want to be...
Wheres best to get the fittings
http://i63.photobucket.com/albums/h131/munroshaun/Mobile%20Uploads/2014-11/20141106_204421_zpstzgiy10k.jpg bought some lines of a guy on here and ended up with this oil line. Any idea what I need to...
Great project am building a mk indy with a sr20 in aswell. Be interesting to know how you went anout your loom and starter set up
I am building a kitcar with a sr20 in and not far of wanting to turn it over once I have the loom in.
I got a full car loom with the motor and was wondering how little of the loom I need. Am...
Am setting up a sr20det engine into my kit car. I've ha Afew s14's over the years and also was the front mount set up. But with this convertion am very tight on space and been looking into charge...
Does anybody know the thread size on the clutch master cylinder. It's the thread size on the fluid pipe that I need to know thanks