Not this time , going nurburgring.
Sent from my iPhone using Tapatalk
Type: Posts; User: tricky890
Not this time , going nurburgring.
Sent from my iPhone using Tapatalk
This is to do with the ECU , had the same issue after I fitted a stage 1 Hdev chip into my mates ecu , exactly what your describing , best thing to do is pull the ecu apart again and move the jumper...
Dude I will sort this for you ! Be patient lol
Sent from my iPhone using Tapatalk
Supra
Sent from my iPhone using Tapatalk
I had this issue on mine , fitted a japspeed. Rad , still had the cowling aswell, it never overheated butvthe bottom rad hose was always freezing cold, I changed out the thermostat and now it’s...
Did you pay on a credit card ?
Sent from my iPhone using Tapatalk
Is this for the parts you bought in sept 2018 ??
Sent from my iPhone using Tapatalk
I think it may be dude nice one
Sent from my iPhone using Tapatalk
Can’t find a post by him mate
Sent from my iPhone using Tapatalk
Anyone know this guy he was a llandow today and sorted me out with some brake pads . I don’t have him as a friend so if anyone knows him can u please tell him he is a legend ! He bought his car from...
Loose connection either on the cable or in the switch itself,
Remove the switch ,Try putting a continuity tester on the switch and tilt and move it about . The. You will see if the switch is ****ed...
110 the fan should kick in by then , also if it's not cooking great your water pump could be on its way out and not circulating the water sufficiently enough
Sent from my iPhone using Tapatalk
If it ran even worse after messing around with the coils I would suggest checking
1) wires to the coil packs
2) check your spark plugs are ok. they can snap on the ceramic insulators.
Sent...
New stat I had this prob on my sr recently after changing to an up rated radiator , turns out the stat had gone coincidentally .
My rad was getting hot one side and not the other, when I floored it...
Have you checked your coil packs ?? They can cause issues when they get warm or if completely ****ed they don't work properly at all
Sent from my iPhone using Tapatalk
Half way thru lol[emoji23]
Sent from my iPhone using Tapatalk
Right it's still in limp mode all solders are bang on and continuity tested all the joints on the ribbon cable all is fine .
So any ideas anyone ??
Sent from my iPhone using Tapatalk
Ok so still had issues but then I checked the Horsham side on the daughter board and found the ribbon cables had snapped on some of the connections, just waiting now for it to be refitted and see if...
Ok cool I had a bit of a nightmare as my soldering iron end fell apart so had to use my 100w and the end is massive
Sent from my iPhone using Tapatalk
so I fitted a Horsham stage 1 chip to my mates ecu , changed the jumper over etc and it wouldn't run properly, engine check light on and strange clicking noises when starting it .
So I changed the...
Big circlips are a must
Sent from my iPhone using Tapatalk
It's left hand thread mate
Sent from my iPhone using Tapatalk
Are you sure your brakes weren't hot and then they cooled and released off slightly ?? Same happened to my bro at the Nurburgring. Although he managed to stop any damage , apart from a few scratches...
Hello mate welcome to the best of the best [emoji23]
Sent from my iPhone using Tapatalk
https://www.turborebuild.co.uk/
Sent from my iPhone using Tapatalk